how to install wall to wall carpet::You may need to enlist the help of a friend to help roll out the carpet completely how to install wall to wall carpet

how to install wall to wall carpet

how to install wall to wall carpet

how to install wall to wall carpet::You may need to enlist the help of a friend to help roll out the carpet completely.
Here is a how to list of what you need to do to get your new carpet installed in your room.
Take some time to diagram the room so you know where the longest and widest sections of the room are.
Take a look at your measurements and add a couple of extra inches to both the length and the width measurements.
This will give you extra room for your threshold and for the seams.
Step 2 floor squeaks walk around the floor surface and check for squeaks.
This will help to minimize and remove the squeaking sounds completely.
Step 3install the tack strip alongside the edges of your room, install tack strip.
The tack strip should not be installed so that it is flush with the wall.
Instead, make sure you maintain a small gap between the tack strip and the wall.
To check the gap, slide your fingers in between the edge of the tack strip and the wall.
Hammer and nail the tack strip into place.
Roll out the carpet padding onto the floor.
Pull the carpet padding as close to the tack strip as possible.
Add extra padding by door entryways and thresholds.
Tack the carpet padding down with a staple gun.
Step 4 roll out the carpet roll the carpet over the carpet padding.
Position the carpet in the room, leaving a little extra carpet along the perimeter.
Fit the carpet to the room.
Make small precise cuts to size the carpet appropriately for the room.
To make the carpet flush against the baseboard of the wall, use a knee kicker and kick the carpet to the baseboard.
Hammer the nail only halfway down.
Repeat this process around the entire perimeter of the room.
Step 5 trim and stretch the carpet trim the carpet next to the wall using a sharp knife.
Tack the carpet down using the side of the hammer.
The carpet should firmly sit into the tack strip.
Do not use the head of the hammer, as it will bend the tack stripping and the carpet will not fit appropriately around the room.
Using a power stretcher, restretch the carpet and fit it into the gully, between the wall and the tack stripping.
how to install wall to wall carpet::The seamed edges of both carpet
segments must be straight how to install wall to wall carpet